How to Perform Water Heater Installation
One of the largest and most important appliances in any home is the water heater. It is necessary to install a water heater properly, as it can get extremely hot and can damage or destroy other parts of your home. Having an experienced plumber complete the installation will ensure that your water heater is installed safely and efficiently. The installation process varies depending on whether you are installing a tank type or tankless type water heater. In general, a tank type water heater can take up to three hours to replace, while a tankless can take between eight and 10 hours.
When determining the amount of time needed to install your new water heater, keep in mind the area you are installing it in. If you are replacing a tank type unit, you may need to reroute plumbing piping to allow for proper usage. Before you begin, you will need to make sure that the room where you are installing the heater is prepared for the work. For example, you will need to clean up the clutter and make sure your pets are kept away from the area. You should also check for leaks. A 50-50 mixture of dishwashing liquid and water can be used to test for leaks. Read more about HVAC at http://www.ehow.com/how_5470100_service-air-conditioner.html.
Your plumber will be able to give you specific instructions for the installation of your water heater. During the installation process, the plumber will remove the old unit and place the new one. They will run gas lines and perform any other necessary work to ensure that your new water heater is safely installed. Depending on the complexity of the installation, you may need to have a second visit. Once the new water heater is installed, it is important to make sure that the temperature and pressure relief valve is correctly positioned and sealed. This can prevent the risk of a leak or explosion. Remember that the outlet for the temperature and pressure relief valve should lead to a drain. You will need a soldering iron. Copper tubing can be purchased from a hardware store. To ensure a good connection, it is best to use a pipe wrench to secure the new valve.
After completing this step, you can start soldering the copper pipe to the opening of the new valve. Keep the tube three to four inches above the ground. Once you have completed this task, you can turn on the water supply and the cold water faucet. Make sure that all the pipes are positioned correctly. As you do, you should take pictures to show the plumber where you made the connections. HVAC company will help the plumber prepare for the job. To ensure that your water heater is properly installed, you should check the local building codes and have an inspector review your work. Leaving out certain parts of the building code can result in fines. Similarly, skipping permits can be costly and a safety hazard. You may also want to consider getting a labor warranty for your local business for ac installation. This will ensure that you won't be surprised by unexpected repair costs.
